Done / Completed **LINEAGE** Foundry Cast ANH Kenobi Stunt Hilts (ANH/ROTJ - V2/V3)

Got my V3! Thanks PPP!

Best ”Aluminium Candle Stick Holder” ever! Haha

Plan on going for a pre Don Bies stunt build. Got everything I need.
Now the fun begins!

9D9E2443-062A-4220-AAA8-B1ACAF8DF6DB.jpegA28F51F1-F934-4B14-BCC6-89E2C0C5C3ED.jpeg
 
Got my V3! Thanks PPP!

Best ”Aluminium Candle Stick Holder” ever! Haha

Plan on going for a pre Don Bies stunt build. Got everything I need.
Now the fun begins!

View attachment 1441767View attachment 1441768

Welcome to the club!

20201105_141658.jpg


PoopaPapaPalps Would it be possible to switch my blank on the 4th run to a V3 stunt? Then could also put me down for another V2 and a Blank in the last run?

Done and done. I've got some machining to do this week so, with any luck, I'll have these out to mail pretty soon and working on the next run after.

Bump for more interest for future runs.
 
Finished putting together my V3. Absolutely love this hilt. I held off getting a V3 for years as I always wanted a cast one.

I did this one up as best as I could to resemble the stunt used in the throne room scene. I took a few liberties. Basically just painted it like the stunt in the warehouse scene and added a clamp and card.

I had an old Buggy Whip that I cut down and used as a blade. It works as a good substitute to using a vintage antenna though I suspect it’s diameter is not as thick as it should be.

The clamp card I used was from a board out of an old decommissioned telecom cabinet.

Thanks again PoopaPapaPalps!

EBFC8207-E34F-408F-89A2-FE4AA57C978D.jpeg

17698944-DAB6-4BCA-AA8E-6D6FD3D263A9.jpeg6072B5BD-8DA4-4A9F-9579-9C9743EB0520.jpegF63A2325-60E6-4F5F-BE5F-EB4B13FC60B8.jpeg430BE157-5F18-4B62-BC21-33EB59FE0E0C.jpegFE2B870A-3578-4EB7-8D12-BB76DA954425.jpeg815F77A5-783F-4E62-A723-A1F55FDFE4E7.jpeg
 
That looks lovely! The gold paint is a great choice whatever it is. And that booster weathering? Totally cool.

The buggy whip is pretty neat too
 
List updated and bump for further interest!

I had to take a few days to visit some family but the 4th run is close to being done. One of the casts proved a bit more difficult to machine. I don't fully understand the properties of alu casting yet, but there might be some hardening in some over others. Some just take to machining easier, while others are a bit more robust. Nothing major but just slower in getting the work done.
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top