Arkham Batarang 3D Print - Flip Action


Fawbish

Sr Member
Hi all.

Not my design this, but printed it, did a few finishing techniques (xtc3d, some rough painting) and added in some 3mm magnets for the loose mechanism. All in all very happy with the result, but picked up some improvements for later. Enjoyable little project!

IMG_2537.JPG IMG_2541.JPG IMG_2542.JPG IMG_2545.JPG IMG_2558.JPG

As you can see, my crude "curve template" ended up causing a little bit of overspray. so next time Ill be taking more care in sticking that down.

And of course a small video in action.

[video]http://tinypic.com/r/aenz3n/8[/video]
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top