Anyone have good plastic (hard hat) repair/polish skillz? Tuf E helmet/hard hat needs attention and some work.

Clerval

Sr Member
RPF PREMIUM MEMBER
It might never be worn, but it's a piece I've been looking for for some time and I'd like to get it into better shape.
I've got a new piece that has a y-split crack and a logo that had to be removed. The y-split is about a 1 cm crack on the three angles, and the logo was imprinted a bit too well, left both an imprint/indentation when stamped and after removing much of the color I see that the elbow grease introduced some dulling scratches etc. A few rounds of Novus hasn't done the trick, and I'm also uncertain on an approach for the cracks. At least the crack is not through the plastic...
joel_tuf_e_hh.jpg
tufe_dmg.jpg
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top