Any Briefcase / Carrying Case Foam Cutters Here?

bobatrek

Master Member
RPF PREMIUM MEMBER
I am looking for someone who has access to and can professionally, or as close to it as possible, cut the foam that would go inside a briefcase or carrying case, as to have a custom fit and protect the contents within, for a prop I creating.

Thanks in advance,
Sean
 
I'm looking into that, but I thought if I could get one with an exact fit, that would be all the better.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top