Forums
New posts
Search forums
Non-stemming search
Media
New media
New comments
Search media
Resources
Latest reviews
Search resources
Members
Registered members
Member Map
Current visitors
New profile posts
Search profile posts
Our Communities
The Dented Helmet
The 405th Infantry Division
Ladies of the Legions
RPF Shop
Log in
Register
What's new
Search
New posts
Search forums
Non-stemming search
Menu
Log in
Register
Install the app
Install
Forums
Costumes & Props • Popular Franchises
Star Wars Costumes and Props
Any advice for gluing up a 3D printed helmet?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Vagabond Elf" data-source="post: 5272749" data-attributes="member: 214944"><p>Most of that snow was a week old... the problem was it had been 2 degrees above freezing and raining, so the roads were sheer ice. Every time we go the van a little loose it just slid back downhill into the windrow again!</p><p></p><p>But the sympathy is appreciated. It's been a hell of a week!</p></blockquote><p></p>
[QUOTE="Vagabond Elf, post: 5272749, member: 214944"] Most of that snow was a week old... the problem was it had been 2 degrees above freezing and raining, so the roads were sheer ice. Every time we go the van a little loose it just slid back downhill into the windrow again! But the sympathy is appreciated. It's been a hell of a week! [/QUOTE]
Your message may be considered spam for the following reasons:
Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.
Insert quotes…
Verification
Post reply
Forums
Costumes & Props • Popular Franchises
Star Wars Costumes and Props
Any advice for gluing up a 3D printed helmet?
Top