Reply to thread

Message: <blockquote data-quote="Corellianexports" data-source="post: 5241968" data-attributes="member: 497">Next up is the left side parts and the flash hider installation.[ATTACH]1504208[/ATTACH]Because the side rods parts are painted as one piece, there's no need to glue anything.[ATTACH]1504209[/ATTACH]The painters tape is removed from the parts and I double check the placement of the flash hider against some of the reference photos.  It's about an inch from where the pistol barrel ends and the extension begins.  I use a small amount of contact cement inside the flash hider and install it on the barrel extension:[ATTACH]1504210[/ATTACH]The side rod is a little loose, so I use a few drops of super glue on both set screws and wiggle the part a bit to make sure the glue gets between the threaded holes and the sets screws.  The prop is left to dry over night.Here's a few "as built" photos of the blaster, completely assembled:[ATTACH]1504212[/ATTACH][ATTACH]1504215[/ATTACH][ATTACH]1504216[/ATTACH] [ATTACH]1504217[/ATTACH] [ATTACH]1504218[/ATTACH] [ATTACH]1504219[/ATTACH]Up next, weathering and final photos.  <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile    :)" loading="lazy" data-shortname=":)" /></blockquote>

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.