AMT Galileo Shuttle conversion kit.

Discussion in 'General Modeling' started by Jet Beetle, Jan 22, 2012.

  1. Jet Beetle

    Jet Beetle Sr Member Gone but not forgotten.

    Trophy Points:
    2,147
    So I purchased one of these augmentation kits that are to be added to your Galileo model -

    the pieces can be seen here

    Hobby-Bid


    These came with no instructions and I've searched everywhere on the web for any kind of guide but have found nothing. Anyone know where I can go or perhaps let me know how these stuff goes together.

    thanks.
     
  2. RGPFX

    RGPFX Well-Known Member

    Trophy Points:
    510
    About 10 years ago, Fine Scale Modeler mag ran a story about upgrading the AMT shuttle. At a guess, I'd say the biggest piece you have is the rear engine facing. In the story, the modelmaker scratched it out of styrene strips and sheets. The photo in the link is too small to even tell what anything else looks like. Sorry.
     
  3. Admiral Nogura

    Admiral Nogura Well-Known Member

    Trophy Points:
    566
  4. feek61

    feek61 Sr Member

    Trophy Points:
    1,486
    So from the photo you have the rear bulkhead, the rear landing strut and pad, the two nacelle landing pads and the back of the engine nacelles
     

Share This Page