Advise Needed: Glue for PLA Prints

Feltman Langer

Jr Member
Hi All,
Just about to finish up my ST Boomerang phaser and was wondering what is the best to glue all the parts up with i.e. recommended for use with PLA printed props.
 

wgdesign

New Member
If BSI is available in NZ like it is here in Australia, that's the 5min epoxy on the right.



IMG_7023.jpg
 

Skyler101

Sr Member
Given the toxic nature of 5 minute epoxy, I don't like using it.

I have found that Selley's Tarzan's Grip my go to when gluing PLA. Its strong enough to hold the parts for final placement, and flexible enough to use for cosplay. Its also super avalible in AUS and you should be able to find in in NZ...


- Skyler101
 

Feltman Langer

Jr Member
Given the toxic nature of 5 minute epoxy, I don't like using it.

I have found that Selley's Tarzan's Grip my go to when gluing PLA. Its strong enough to hold the parts for final placement, and flexible enough to use for cosplay. Its also super avalible in AUS and you should be able to find in in NZ...


- Skyler101
Cheers- yes my local Bunnings stocks it :)
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top