Reply to thread

Message: <blockquote data-quote="Chris Moliere" data-source="post: 5255589" data-attributes="member: 195847"><p>I'm in the process of trying to design a mold for a complex part, this globe for a gumball machine used on a puppet I'm in the process of building. However, I've run into some complications, due to the design of the part. It's hollow, but it has to be a specific thickness, and due to the interior structure of the part making a mold of the inside would be difficult, if not impossible. In order to make it exact, there's also a seam inside the piece that needs to be replicated, so making a mold of the inside is a necessity. I've attached some photos to explain the part's design. Any ideas on how to make a mold that would replicate these requirements would be greatly appreciated!</p></blockquote><p></p>

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.