Adding on to your bio?


New Member
Hey all, I have a raw bio and am wanting to add on to it to make it look like an axertor bio. Does anybody know of a good/light material to use for shaping and then possibly gluing to the bio? Any suggestions are appreciated!

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.