Adam Savage's Mythbusters Toolbox

This is most excellent.

If for nothing more than the meta-recursion aspect of it, I would be down for getting in on any would-be run of these. I've been a lurker on the RPF for years, but watching Adam on Tested lately has gotten me inspired to become more active.
I might do the AS Toolboxes.
Adam says they are .040 6061 plate. I knew that was thin but at the metal yard I thought wow that's really thin.
I just need a reality check on that? I'm sure it will sturdy up with corners and rivets I was just surprised. I've done metalwork but usually structural things in steel 3/8" and bigger so I'm probably just used to that.
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.