Accurate Darth Vader Helmet STL?

so it's the new year and we are starting off with a bang I decided to look and I found this on artstation for 50 bucks
1642188297530.png

1642188456818.png


but what's different about this is that it's a reveal style
1642188433709.png

with a lot of detail
1642188500842.png

1642188512810.png
1642188531224.png

and has an stand with it so you can display it open
1642188586427.png

1642188630941.png

so if you gents want to take a look at it here's a link to it https://www.artstation.com/marketpl...ep6-helmet-reveal-for-3d-print-3d-print-model I think I'll rate it a 8.5/10
 
Last edited:
so it's the new year and we are starting off with a bang I decided to look and I found this on artstation for 50 bucks
View attachment 1533948
View attachment 1533954

but what's different about this is that it's a reveal style
View attachment 1533953
with a lot of detail
View attachment 1533955
View attachment 1533956View attachment 1533957
and has an stand with it so you can display it open
View attachment 1533958
View attachment 1533959
so if you gents want to take a look at it here's a link to it https://www.artstation.com/marketpl...ep6-helmet-reveal-for-3d-print-3d-print-model I think I'll rate it a 8.5/10
Its also on cg trader but JUST THE HELMET.
 
Or this.
For free that file is bluddy fantastic it has the compressed nose bridge, the rounder eyes like the quasi/RO/Kenobi and the incised lines on the tubes like RO/Kenobi however I'm not too sure about the dome it looks like it should be tilted back further and once thats done the bottom edge should be trimed by about an inch or two I think.

But yeah If you want to print a RO vader costume and not have to pay for this is absolutely for you but as I said before you will have to modify the way the dome sits then shorten the bottom edge but If your looking for a starter helmet and then wish to upgrade then this is the way to go. if you want something more accurate and you want something you have to alter or replace for the sake of accuracy then I highly recomend this file for $18.99


 
Last edited:
No problem. By the way, do you know if there are any problems with the anh one?
Well the bottom edge of the dome is really flat and there appears to be no pointed windows peak so no its not good for an ANH maybe a HIGHLY cleaned up and symmetric ESB or something, you could use the tusks I guess but they won't go down well for pepakura stuff.
 
If you want to go down the ANH route then I'd get the ROTJ face from darthrobin from thingiverse and make the bottom triangle smaller, In fact a pep ANH helmet would work better than a print because the ANH Vaders quite battered and paper moves and dents easily and its very hard to get a pep helmet flat and symmetrical as you may know
 
Last edited:

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top