A little question on heat

swift kinfe

New Member
I was at katsucon today(ironic lay I saw a guy in another pred out fit wearing the costume and deluxe rubies head)I was burning in my costume and had to remove it twice so I wouldn't hurt myself.I was wondering if anyone had an Idea on heating in suits.I'm gonna stop with my pred for a while to start different things.I was thinking about a phase 1 clone trooper as I already have the helmet I think this might be a good idea is it worth getting started?
 
i've seen an "AC" unit that uses a small motor drivin fan under the dreads and uses rubber hose that goes into the dread hoels in the back to circulate air.. its somewhere on the forum
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top