So like a lot of us, i drift from one project to another, and back again.
Spend too long on one and get bored so do another for a while.
After spending ages on my 1m long Omega class Destroyer (1m long Omega Class Destroyer from Babylon 5), i needed to do something different, so after finishing off a 1/35 military kit, i switched to another spaceship.
Have finally finished designing my Sulaco for 3d printing. She's set to be about 800mm long, which will actually fit on my bookshelf.
The antenna etc on the front are about 150mm of that 800mm, so she actually seems quite small. It would scale up (or down) though, just have to use bigger screws.
I started printing it last night, and will be a couple of weeks until all the parts are made, havent done a count yet but guessing about 150-200.
Am still adding detail to 2 last parts, the front face where the antenna mount (adding piping, ducts, panels etc), and same on the rear engine panel.
Theres still a lot of scope for adding detail with styrene, and she'll have a 12mm aluminium tube running down the centre for strength and rigidity.
I've made the dropship bay underneath open so i can light it, and am working on a little drop ship to put in it, but thats only going to be about 30mm long so wont be heavily detailed.
Thoughts, comments, etc?
This is the model:
Spend too long on one and get bored so do another for a while.
After spending ages on my 1m long Omega class Destroyer (1m long Omega Class Destroyer from Babylon 5), i needed to do something different, so after finishing off a 1/35 military kit, i switched to another spaceship.
Have finally finished designing my Sulaco for 3d printing. She's set to be about 800mm long, which will actually fit on my bookshelf.
The antenna etc on the front are about 150mm of that 800mm, so she actually seems quite small. It would scale up (or down) though, just have to use bigger screws.
I started printing it last night, and will be a couple of weeks until all the parts are made, havent done a count yet but guessing about 150-200.
Am still adding detail to 2 last parts, the front face where the antenna mount (adding piping, ducts, panels etc), and same on the rear engine panel.
Theres still a lot of scope for adding detail with styrene, and she'll have a 12mm aluminium tube running down the centre for strength and rigidity.
I've made the dropship bay underneath open so i can light it, and am working on a little drop ship to put in it, but thats only going to be about 30mm long so wont be heavily detailed.
Thoughts, comments, etc?
This is the model: