Unlimited Run 3D printed Turbolaser Tower1/270 for FFG board game

[FZ6]

Hello guys.

I've designed a very nice 3D printed turbolaser tower for the FFG board game in 1/270 scale.

This turbolaser is a very close replica of the ones seen on ANH. It has all the little details of the original studio filming model.

This tower has a highly detailed swivel turret and the cannons can go up and down. On the picture you can see the medium size.



It's available at Shapeways, in White Plastic. You can sand it and paint it. It's available in three different heights: short, medium and tall.

This tower is available also as a kit, to be assembled. this way is cheaper because the printing volume is reduced.



You can see my turbolasers here:

https://www.shapeways.com/product/767MGBYW9?li=shop-results&optionId=55919816

https://www.shapeways.com/product/FS7G9DRJK?li=shop-results&optionId=43152999

I've designed too a destroyed version of the turbolaser:

https://www.shapeways.com/product/ZGK4UFBK6?li=shop-results&optionId=42694198



Many thanks for watching!!

 

[FZ6]

A short video to see the turbolaser tower...

Many thanks for watching

 

[FZ6]

And here is the destroyed version of the tower, that you can see also on the video.



Many thanks for watching!!

 

[FZ6]

An upper view of the turbolaser tower.

You can see the visible high detail on a part printed in White Strong Plastic, not in Frosted Ultra Detail resin.

This turbolaser is a perfect replica of the studio filming model. The best turbolaser you can purchase actually.



Many thanks for watching!!