3d printed strap anchors

behnt

Member
RPF PREMIUM MEMBER
EVA foam armor tutorial on how to add straps to your foam armor or foam props using a easy 3D print. Cosplay made easy, strapping is a issue no more :) How do you strap your foam armor? Let us know in the comments below! Thingiverse link to the files is here:
https://www.thingiverse.com/thing:3524635

 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top