3D printed Aliens motion detector

TheSt.LouisKid

Sr Member
3D printed in PLA so it was a snot to remove the build lines. The slide viewer is an incorrect GAF slide viewer(and not 3D printed) which isn't screen accurate but i don't care. I made the base from some acylic block I had laying around. It lights up. A fun project.
 

Attachments

  • MD03.jpg
    MD03.jpg
    349 KB · Views: 112
  • MD04.jpg
    MD04.jpg
    220.5 KB · Views: 121
  • MD02.jpg
    MD02.jpg
    230.1 KB · Views: 132
  • MD01.jpg
    MD01.jpg
    215 KB · Views: 122
  • MD05.jpg
    MD05.jpg
    491.1 KB · Views: 116
  • MD06.jpg
    MD06.jpg
    366.1 KB · Views: 127
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top