3D Printable BvS: Dawn of Justice Symbol

Fawbish

Sr Member
EDIT: Mod may wish to move this to DC Section, posted here by mistake.

Decided to fill a little time the other day by chucking a quick design together based on the new symbol from Batman vs Superman film. I normally shy away from logos and such but this one was just pleasant to sit and design. I completed it a little differently to the one that shows at the end of the latest main trailer, so the Superman symbol is recessed into the bat symbol, but then is also slightly raised where the curves are on top etc.

The design is as below, and it is also on MyMiniFactory (https://www.myminifactory.com/object/batman-vs-superman-dawn-of-justice-symbol-6801), where I am slowly building up a collection of designs. 2/3 designs are currently pending review.

symbolfront.PNG symbolright.PNG

And MyMiniFactorys print

printed.jpg
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top