1/4 NECA spear and skull/spine

Mark Reed

Mark Reed

New Member
Hi
Guys...and Gals
I am trying to track down a expanding 1/4 Neca spear for my City Hunter, also looking for a skull with spine (1/4)

Fine lots of 1/6 skull/spine but no 1/4, did anyone 3D print some?


Thanks
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top