1:2 Scale Jurassic World Indominus Rex Bust....

yankeetrex

yankeetrex

Active Member
Finally Finished my 1:2 Scale indominus rex bust after having it printed for over 6 months sitting in my office. I sculpted it in Zbrush, printed on my Creality Cr10s, and painted it with Createx Bloodline colors.

zMCoLPG.jpg


ICoSVWC.jpg

M5PHPvv.jpg
iKyoyd6.jpg
lsSTmMJ.jpg
 
Dingo80

Dingo80

Well-Known Member
RPF PREMIUM MEMBER
I don't know if I should stare in awe or run and scream in fright that I might be eaten! AMAZING job! Even at just 1:2 scale, your paint job on it is awesome!
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Similar threads

Stivie
Bilbo's writing desk build 1:1 from LOTR
2
Replies
36
Views
2,854
Stivie
Stivie
Zombie Killer
Men in Black 1 Neuralyzer build
2
Replies
23
Views
4,147
LuckyS7evine
LuckyS7evine
modelnut
I need advice on finishing a 3D printed Babylon 5 PPG
2
Replies
22
Views
966
Noeland
Noeland
Batwillz
Popcorn (1991) ‘Shock Clock’
Replies
1
Views
118
Brainscatters
B
CntAllBeWinners
Who Framed Roger Rabbit - Toon Revolver - WIP (Finished in Post 10)
2
Replies
20
Views
1,169
DemetriusPharos
DemetriusPharos
Top