1/1000 PHASE II Enterprise


Gregatron

Sr Member
Photos to come (eventually), but I’ve been working on fine-tuning various details, and to install the printed nacelle grills and tiny secondary hull docking ports. I also decided to make use of the printed nacelle front-end master I’d previous received by carefully sanding and shaping it to fit the contours of the nacelles. Once that work is done, I can mold and cast the master in clear, tinted resin.
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top