1:1 The Child aka: Baby Yoda WIP (Yes another one)

VashDstampede

Sr Member
RPF PREMIUM MEMBER
I have the Sideshow 1:1 The Child on pre-order and I told myself I don’t need to sculpt one of these because of that reason.
However, I was stuck at home last week and needed to relieve some stress one evening, so I picked up some clay and started working on this little guy.
I haven’t sculpted in a while so I’m a little rusty, so here’s where I’m at so far after a couple of short sittings.
Still a bit to go and I’m still working on if I want to change expressions, etc. I did want the ears to be bending down a bit.
I don’t get much time to sculpt, so it may take a while between updates.

Anyway, here’s the little guy so far:
EFBD9E64-015F-423E-A3FF-4FD16E833CEE.jpeg
B5AF4E10-48F7-4430-AB61-E80E2467940C.jpeg
53577E5C-356F-4B1C-AE5B-B9761E4F8A41.jpeg
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top