Recent content by plasmajunky

yes sir I agree although the fallout wiki says the t45 armor is gray jut wondering if anyone had any more accurate info Thanks For the help Zapwizard

Hello again Got my borderlands 3 Buzz axe done but I cannot find a good still in game paint reff. anywhere. Only found one in a how to vid from some fella speaking Russian. Plenty of BL 2 but no BL 3 reffs. Any pic or screen shot someone my have would be much appreciated. Lastly what would...

Dumb question but I am trying to decide what color the in game T45 helmet is (BOS) is if metallic or bare metal or gray. Any ideas Thanks Jerry

Hello fellas and gals real quick does anyone know where to find good tested Iron man helmet and armor stl files. The helmets are to be honest everywhere but am wanting some guidance on a good relatively accurate tested 3D file or should I say files for the armor . There are so may Variations...

Thanks guys totally appreciate the info and thanks Zinger, I have made close to 70 or 80 molds just never for roto cast all slush or small block molds as well as a few clamshells for bigger stuff like a full sized guitar. I like the fiberglass idea as it will most likely be cheaper than plasti...

Also Zinger Where you say mother mold. I usually do a 2 part clam shell bolted together but I use smoothon's mother mold material but yes its expensive and heavy. So what I am interpreting you saying and ( it makes sense) Keep the mold light so...…...after I get my silicone laid you prefer...

thanks zinger I appreciate the info I do have another question what is the fitting called (for lack of a better term) to get elect power to the inner frame motor through the outer frames shaft ( so the wires don't all tangle up)

Thanks for the help fellas

Hello I am working on building a roto casting machine and was just wondering if anyone, Has done one and can direct me to decent plans ( for a metal frame welded unit at least 3X3 ) Or at best answer a couple questions one being the gear ratio between the inner and outer frame. would you run 1:1...

Thanks for the reply and your right ….I had to learn that lesson the hard way myself. Thanks Again

Hello Yall and happy new year anyway just a quick question. anyone who likes the fallout series and 3d prints must know the modeler Lillykill from my Minie factory and thingaverse. I had saved a few of his works to print later and well its later, but all his stuff is gone did we or someone make...

Hello Fellas I am at the point of painting my Se14 and was wondering what color it actually is ? In doing a search i see everything From black to silver. as well as gray. I have not had the privilege of seeing or shooting a rexim as I have the sterling so I have nothing to go on. The Black...

LOL yes A clip loads a magazine and a magazine loads a rifle, and yes that is correct for the bottom of some sterling mags

Is this helmet smaller than what would be considered screen used? I am still trying to get some rough dimensions to see if the one I have is way to big. would you mind taking some measurements across the dome side to side as well as front to back and if you have time from the level position how...

Thank man I appreciate the kind words. And that is why I keep coming back to this board, as someone eventually steps up with the right info. The collective knowledge on this board never ceases to amaze me. Thanks Jerry