When I printed most o the pieces I did end up breaking most of the pieces into smaller sections. try to find seam lines where there might be an easy break you can hide or even a slice where it'll be so far inside most people won't see it. I think I had my internal booster broken up into like 3...
The way this was modeled isn't exactly printer friendly. I do not say that as a dig to the modeller. I refer to the amount of 90 portions internally that causes this. It's a beautiful free model and it simply takes time to learn how to set up the large tall prints for success.
But this pack...
The lettering for the film suits were offset silver on top of orange with no border.This is the best image I have from a research group on Facebook of the nametags.
Yes that is exactly correct.
You can I theory make your own 45 degree angle supports but it involves turning the object in the slicer to do it and then turning it back.
Essentially a slicer will only build supports straight up either from the bed or in objects as well.
There are tree supports...
This is more or less what I'm talking about, if the pieces are small enough ( not tall on the print bed, then nothing wrong with supports. And honestly this is just for ease of printing, but these are things I had to incorporate into models to make them print faster and with less material.
For 3D printing purposes, inside the cannister if there are any 90 degree angles, it would make a piece easier to print if the angle was 45 degrees instead. adding that extra angle instead of a 90 degree cutoff means you don't have to use support material which in the case of the rocket pack...
I imagine this works really well on say large prints with less detail. but the more detail you have the less effective it is as it will just cover it up and soften your corners.