Recent content by jeffreygullett

Painted the ram skull for the staff today. The color doesn't show well in the photo. But it's kind of a metallic pewter now.

I'm also printing out a new skull mask. I still have the latex mask but I think it would be cool to have a rigid articulated skull mask. I'll see how it turns out.

Behold Minions! The new 3D printed skull for my Chaos Staff!

I'm doing some more work on this costume. Making a new staff with a 3D printed ram skull I'll post pics when it's done. The final piece is printing now. Now that I have the actual statue I'm going to make some adjustments to my costume as well. Will be taking it to SDCC again this year!

Looking fine! Question: is the chest still made out of the plastic from the cans? So just the shoulders are Worbla?

Great job! I tried this costume a while ago and had the same nightmares about the shoulder armor. You've inspired me to try again. I have some Worbla laying around.

You can buy the mark 7 model from do3d. That's what I did. It's pretty good so far but the hands are incorrect. Your helmet looks good but is not accurate for a mark 7 if you decide to go that route. Would work for a mark 3 though. But I have yet to see files for that either.

Do3d sent me new finger files as the ones that came with the mk7 were totally wrong as well. Now I just need to work out scaling. I printed out the devildog hand files and they are a tad too big. I don't want to waste anymore filament until I work out how to either scan myself or measure and...

Thanks for the tip. Those files are much better. Reprinting the glove now. I kind of figured my first spool of filament was to blow on learning anyway.

I'll take a look. Thanks.

Are you sure you're thinking of the Mark VII?

Just bought them. These are the only ones they sent me.

I thought I was out. But now I've been pulled back in... I made an EVA foam Iron Man Mk VI a few years ago. I thought I was done with Iron Man. But then I got this... So now I bought a model of the Mk VII from http://www.do3d.com/. After much trial and error with various test files, I...

Heat wasn't bad at all. Luckily it cooled down that day and inside I was fine. My biggest problem was my chest harness was slipping back. You can see how the chest piece is too high in the photos. I need to remake that. Oh and when packing up to head home, my staff fell and the ram skull...

From SDCC 2016