Recent content by FreddySchramm

I definitely had the leaf idea, I might as well give it a try. I'd like to sell these in a high price later on so I might just have to resculpt something and cast it.

I sculpted this Beetlejuice shrimp hand and casted several in latex, I sculpted it based off of Tom Spina's restoration photos. In the scope that didn't realize the fingertips were a little bit different than what we see on screen. The shrimp tails I decided to replicate by cutting and...

So I just discovered this type of spray paint used on Star wars and Harry Potter. I'm looking to give it a try but it looks like I can only get it in the UK and rather than pay for an expensive amount of shipping I want to know if there's an equivalent that anyone knows about that's here in the US?

I'm doing a mock-up of the steel frame. These 3/16 wooden square dowels are scaled perfectly to represent the 1x1x.120 steel tubing I'll be welding together. I'm not a structural engineer, but I know the fundamentals. I want to see what's going to take the most stress in what I'll need to...

Almost hav enough info for how much foam to purchase.

It was either this or bid on Elvira's dress, come October.

I'm going to use my stimulus check to build something I've always wanted. Half scale ATST measuring about 15 ft tall. I know there's a lot of ambitious projects out there that never really get finished but the way I'm going about this should make it relatively simple enough to finish. These...

Well it ended up working out.

Really? I've always been under their impression that silicone will stick to silicone Even if the bottom layer has already cured fully.

Just so I'm on the same page with what you're saying. Is this what you're trying to describe when you're talking about creating a thicker shape along the parting line? Making a giant stripe on top of the build up silicone And then cut into that?

Would love some opinions on my molding process from the think tank. I'm planning on molding this Wed clay sculpt using a brush on silicone. (Hoping to get a very long life out of this mold) Im going to crystal clear it beforehand. As far as my part line goes, I'm thinking of jewel cutting a...

So this Halloween I tried doing another mashup and have a good project to film for my channel so I give you a cringe costume mashup.You might have seen this online on facebook already. Exotic-Man! Also Gave Me an excuse to make armor for my cat.... she didn't like it one bit.

I got Bored and needed a new portable airbrush set up so I made this one. It's built around a clamp so it's easy to move around the shop, has a compressor fitting that can run to two airbrushes, and has two separate storage compartments for rando airbrush stuff. Here's a video on how I did it

Nicely done. Is that body all one 3d print or did you use PVC/ ABS Piping too?

I started a youtube channel recently. Just posted a video on a few techniques on how to achieve real rust finishes with metal paint and powder and ways to seal them. I use these Helmets a lot for swatches