Recent content by DirtyMoose

If I had enough time and space to do it I would! Thanks for the kind words :) Dirty Moose Design

Finally it is finished! Was able to make a plaque and mount the skull after its final paint job! I will be selling castings and finished skulls on my etsy account. If your interested in here pm me! Dirty Moose Design

Got the rest of the molds done and was able to mock up a test skull! Dirty Moose Design

Well I'm happy to say the biggest and hardest part of the mold for the dragon skull is a success. Every single spike and tooth pulled great! Put a little weathering on so I could see the detail :) Dirty Moose Design

Finished up the upper skull mould! Just a coue more small ones and its off to casting! Dirty Moose Design

Mould is looking good for those half of the jaw! Onto the other side. Dirty Moose Design

Hahaha i had the exact same thought today! The toothpicks are for venting, Im hoping it helps with all the horns!

started on the lower Jaw! I split it in tow to make it easier to mould. Using a simple two piece poor mold for these two. I also got my first layer done on the upper skull (2nd half) done. Starting to see the end of the tunnel! Dirty Moose Design

Forgot to show the "wings" on the upper half of the mother mold. Dirty Moose Design

Ready to start the second half of the upper skull. By far the hardest mould I have tried to date! Slowly but surely argh. Dirty Moose Design

Slow and steady! Hoping to finish the top half of the mold today! Dirty Moose Design

Added on the second layer of silicon! Dirty Moose Design

Dirty Moose Design

Hey there! Just wanted to share the progress on this project on the RPF. I will most likely have castings available when the mold is done! Dirty Moose Design

Hey Everyone I finally got my Kickstarter together to raise money to mold this very large skull! If anyone is interested you can follow the link below to help support my cause and receive a casting or a fully finished sculpt...