Recent content by CallsignFallout

  1. CallsignFallout

    Mandalorian Armor Build

    ok so long time no see. Been busy. Also signal is horrible where I’m at. Anyways after a long thought I really want to use Sintra for the armor but I have tons of eva foam on hand, so I think I’ll do eva armor and someday do sintra armor.
  2. CallsignFallout

    T-45 power armor build!

    I should, but I do believe I’ll start back as soon as my mando armor is done.
  3. CallsignFallout

    Mandalorian Armor Build

    Ok thanks for the advice I will give it a try.
  4. CallsignFallout

    Mandalorian Armor Build

    Ok so I’m new to this specific part of the forum. I know there are some 501st guys here maybe even mandalorian mercs andnothers I could possibly get tips from, anyways I’m building mandalorian armor for the next comic con in my area( hopefully they won’t skip out this year ). I have painted my...
  5. CallsignFallout

    T-45 power armor build!

    I apologize for the long absence but allow me to explain. I had run into technical difficulties with the helmet. Couldn’t get it to print right then all of my files for the project mysteriously disappeared with an update on my computer. . I quit after that. So I’ve decided I’ll put this project...
  6. CallsignFallout

    T-45 shoulders?

    I think I may have said it before but I found some files that worked on Paper Craft Square if you type in Fallout, power armor, or t-45.
  7. CallsignFallout

    T-45 power armor build!

    This is a side build I did while my dremel was charging. It’s a .45 auto pistol from fallout new Vegas.
  8. CallsignFallout

    NCR Ranger Armor Build

    Looking good! I know if I had a 3D printer it would make prop making a lot better for me.
  9. CallsignFallout

    T-45 power armor build!

    I plan on using pepakura for the helmet and going for the fallout 3 with a bit of Vegas mixed in.
  10. CallsignFallout

    T-45 power armor build!

    I finished up the cod piece today. I don’t know what you want to call it but the container over the back was a bit of a pain to put together. I had to make a few cuts in the top to reduce the stress a bit so I will put some buckles on it to stabilize it to the chest piece(coming soon, I hope).
  11. CallsignFallout

    T-45 power armor build!

    Thanks for the advice! It’s taking a little bit to build but I’m currently working on the boots.
  12. CallsignFallout

    T-45 power armor build!

    So after fiddling around a bit and adjusting the design of the shoulders I finally finished them. It’s not exactly what I had planned but it’s close.
  13. CallsignFallout

    T-45 power armor build!

    Well I think I’m just going to go ahead and post the picture of my forearms because the shoulder pieces aren’t wanting to stay together.
  14. CallsignFallout

    T-45 power armor build!

    So recently I asked about t-45 shoulders and I came up with my own foam ones after about 3 days. This thread will be my build progress on the armor. So far I have completed building the fore arms and I’m working on the belt, boots, and finishing up the shoulders. I will try and get some pictures...
Top