Recent content by blickfangQ2

Unfortunately I have to face some problems. When I sand the original paint comes off and reveals a rubbery 2-3mm silicone coat before I get to the foam core. To seal that silicone I tried to use Mod Podge but I really disliked the stroke lines I got even when using a foam brush. So I tried to...

Verrry nice collection!! So clean and nicely ordered. Great!

So another weekend and I made some progress: Did some cable management and pulled all the cables with the cords I poked earlier. I really underestimated how stiff the foam core is. Printed the back covers for the lights in white PLA so I get the most brightness out of the led lights. Will add a...

Cable Management: I use a thick steel wire to poke through the foam core. Angled the tip on one side so I can twist the wire to change directions. It’s a lot more complicated than I thought though… for the longer distances I go from reactor to reactor instead of all the way to the collecting...

Starting cutting:

Started printing and wasn’t satisfied with the results. So I threw the parts on my resin printer. Much better! Built the reactor screw in fusion360 :cool:

Hi everybody, every once in a while I take opportunities that present themselves. I was able to get my hands on one of the last NECA 1:1 IronMan 46 statues in Germany. Since the finish is questionable to say the least, I knew I had to overhaul the whole statue and finish it closer to my...

Do you still have the files? :)

I love it! [emoji2956]

Top part of the shoulder:

Wet sanding with a 400 grid paper: First coat of silver/grey: Masking tape: One coat red: And removed the tape after 10 min (so still wet!)

A little more progress :)

Reprinted the middle part: Aaaand printed the top part [emoji4] Adjusted my printsettings further... looks pretty pretty [emoji16]