Yeah that isn't the issue and only pulls it in 1/2". Theres like 3-4" of space from the back of my head to the rear cap. I have been chopping it up and modifying and got it to fit closer. I need to clean it up and touch up the paint as its still a work in progress.
Thanks for the vid recommendations!
That’s not that difficult and my buddy has a glo forge for the lenses. the sockets are the rough part I need to figure out.
The wiring is easy you got this! It’s only 2 wires so basic.
Had anyone attempted to trim down the back part of the Legends helmet to suck it in closer to the head?
I feel like I could pull this off…..I’ve done harder mods.
The prints keep on coming! I have shins now! Sanding. Printing. Repeat.
I took a small break and made my wife’s Pepper helmet.
Just started the first thigh. 3 day print!
Printing printing printing.
Working through helmet sizing challenges. It feels like it’s 2-3% too big but I’ve moved on to other parts.Nothing like 2 day print failures!
Right boot is almost done. Gonna work for the feet up.
So after a few failed attempts at friends printing this for me, I have got a printer and started going down the road myself!
Just got it all set up and starting to print a new bigger helmet, as the one I had was just a bit too small for the electronics to fit and was really hard to get on and...
Wore my Han shirt, vest and the main part of my belt( no accessories). Got a little flak going in. It changes depends on whose working. Play it safe or be prepared to walk back to you car and drop stuff off.