What's the best silicone on silicone release agent?

Birdie

Master Member
RPF PREMIUM MEMBER
I ususally use vaseline, but looking to find something with a thinner finish.

I read on another forum that any gloss acrylic spray paint will do the job. Anyone tried this?
 
Last edited:
I use Epoxy Parfilm. It's in a spray can and is a wax release. Just google it and you'll find a distributor. It also works great as a release for urethane/resin castings too.
 
I've used enamel and lacquer spray or brush paints and acrylic paint brushed on. All work just fine as a barrier coat and the first test casting from the mold will take the paint with it. FWIW.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top