Sandworm from Beetlejuice--need some input

I'm thinking of making a sand worm (head only) to go over the a/c duct (large industrial kind) which would be the body. So that when the a/c is on, the air will push a ribbon or some fabric around acting as the tongue, if that makes any sense at all.

What should I use? i was thinking paper mache as it needs to be light. Also thinking of using a large balloon underneath to get the initial head shape. Any tips or pointers? i haven't paper mache'd since I was a kid.
sndwrm2.gif

Sandworm.jpg
 
Hmm..
I would say build the structure out of wire hangers. Then paper mache over that. You will then have full control over the way the mouth and everything is shaped.
Hope this helped.
 
I think a wire mesh frame,armature wire and Super sculpty or Apoxie Sculpt would be better.You can build it in sections and assemble later/as you go.
 
Last edited:
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top