Painting Pink Foam insulation board

SethB6025

Well-Known Member
I am building up a one-off blaster, it's primarily made from several layers of pink insulation foam. Regular ol' Krylon took very nicely to the test piece, but is there something more durable that's compatible with foam? Would an epoxy paint work? I was hoping to strengthen the surface to make it more rigid & less touchy. Any suggestions would be greatly appreciated. :)
 
This stuff works great on sealing foam its called
URESHELL
and it makes a nice hard shell coating on foam I have even placed fiberglass
inbetween coats, It has the texture of Latex house paint
it has a 25 minute cure time and you can use a brush or roller
hope this helps

TK648
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top