32" Millenium Falcon V.2

Great build!
Would you mind telling me how you make the surface panels with the notches. Is each notch cut out with a blade or do you have a 'notcher' that cranks those out.

Thanks
O2b4wln
 
Each notch is handcut with a blade, I dont think they used a nibbler on the 32", the notches are too much uneven, the smallest I measured are about 2.5 mm, the bigger are between 5 and 6 mm. I could be wrong though and maybe they had several nibblers with some of them being extra small ! :)
 
Last edited:
I was about to say: "clean build Monsieur Tox"...but since you're leaving file marks and glue all over the place:rolleyes. Naahh, just kidding: great to see such update on another of your great project:cool
 
You've no idea, how much I enjoy this. I'm floored. So amazing!

May I ask,which kit donates the M1A3/M16 chassis?
The new Dragon kit of course is different from the one you (and ILM) used:

Thanks in advance :)
 
Last edited:
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Flyscriber
Millennium Falcon Five foot gun turret scratch build.
Replies
4
Views
576
Flyscriber
Flyscriber
G
One More 5 Footer Falcon
Replies
18
Views
1,710
joberg
joberg
RealDaveWinter
5' Falcon base hull building
10 11 12
Replies
220
Views
13,697
Studio Kitbash
Studio Kitbash
PAULH
My Robocop 2 Cain
Replies
15
Views
868
PAULH
PAULH
Boxcar Bret
Probe Droid Pod (232 version) *Updated 2/4*
2
Replies
25
Views
2,954
el toro
el toro
Back
Top