32" Falcon My First Scratch Build

Thread starter jawsmodels
Start date Sep 15, 2009

3d-builder

Sr Member

May 14, 2010

#161

No worries..... just remember your plugs have to be strong enough
to stand up to heat and vacuum! If it's an industrial rig then the plugs
need to be even a bit tougher! :thumbsup

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.