Need help! clay wont come out of mold!

Hecubus114

Sr Member
RPF PREMIUM MEMBER
I made a mold of a bust sculpted in chavant soft. It is a polyurethane mold, but the heat of being inside has turned the clay to a paste and it is stuck all over the inside. isw there anything I can use to make the clay come off??? And yes, I used generous amounts of mold release beforehand...
 
Naphtha will dissolve chavant, not sure what it will do to polyurethane however. I'd test it before I tried it on any critical areas.
 
Freezer method works fine. Unless you have a freezer that will go to -200 or so . . .;)

Also, alchol works great, as does dish sop and toothbrush.
 
thanks guys, I thought for sure this thing was ruined... which would have been a huge downer because it was a project I've spent a LONG time working on thus far...
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top