1st GHOST TRAP

Zander

Active Member
I have a lot of MDF from my pack build, so I am making a trap with it. ^_^

2335_1392972727.jpg

2335_1393507614.jpg

2335_1363234709.jpg

2335_1385387578.jpg
 
OK!

So...i kinda lost my old trap cartridge...so...I made a new one!

I decided to redo the inside cartridge. This time I made it out of a block of Styrofoam.

2335_6975842329.jpg

2335_5467808399.jpg

2335_7659751222.jpg

2335_6975464100.jpg
 
Small update:

Block has been covered in putty and sanded. Just added the side things at the front and added putty to them.

2335_8138814051.jpg

2335_5385688046.jpg

2335_5199691185.jpg

2335_3451270970.jpg
 
I'm interested to see how this comes around. Are there switches and dials that need to go this after the paint? I'm drawing a blank a what it looked like in the movie.

I haven't seen Ghostbusters in ages!
 
I am also keen to see how this turns out, I love Ghostbusters. And the ghost trap was always a wicked prop :D
 
2335_1901744649.jpg

2335_1497536409.jpg




Doing a little work on the trap today.

Still need to make the handle, cut the plates out of the plastic I bought, paint them, and attach them to the trap.


This trap is a "Stunt Trap" and may not come off my belt at all. So there will be no wheels, the doors dont open, and I may not make the foot pedal.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top