Doctor Who Satan Pit Bolt Gun - finally done!

Birdie

Master Member
RPF PREMIUM MEMBER
Seems like I've been playing around with this prop for ages. I finally got the impetus to get this thing done about 6 weeks ago, and I think all the hard work has really paid off - I think this is one of my favourite scratch-builds I've done :D

9ixok9.jpg


xao2mg.jpg


fjdgnp.jpg


16ktk3n.jpg


amjci.jpg


2iblysn.jpg


wvxus2.jpg


fz7khl.jpg


149wfp5.jpg
 
Last edited:
That is freakin sweet, you did a incredible job! What did you end up using for the bottom piece, the kickstand looking thing?
 
The kickstand part I ended up getting laser cut from 3mm acrylic, wasn't happy with my original attempt. The shrouds were built from styrene then cast in resin. The barrels and bolt are aluminium.
 
Last edited:
GO DOCTOR WHO PROPS !!!! Great job - looks like it was ripped right off the set! ( ... it wasn't right .... ? ) :cool Love it.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top