Smooth-On resin? Need some help/info

How workable is the roto material? If you have to cut out, say, eye slots, does the material sand well or does it remain squeaky, rigid and intolerant to any modification?

Also, how heat resistant is it, or will things start to "melt" if worn too long out under the sun?


I have a patch of 300 that I spilled on my outside work area. It's been in the sun for abotu three months now. Other than turning yellow, it's as hard as it ever was. I've chiseled some of it off, but it takes a thin layer of concrete with it.

Scott
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top