A question about casting a bust... NEW QUESTION

Hecubus114

Sr Member
RPF PREMIUM MEMBER
Is there something cheap I can use to make a first casting just to make sure the mold came out as hoped? Before I spend $$$ on something more expensive? Would plaster in a polyurethane mold be a bad idea? Is there something I could buy, say, at Lowe's or wherever that could be used to make a hollow casting? I just want to be sure it comes out looking how it did going in before I waste a bunch of money on casting material...
 
Last edited:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top