Wall*E Prop - Super Fast and Easy!

Kylash

Master Member
RPF PREMIUM MEMBER
Not 100% accurate, because i believe there is no cooler by Igloo Playmate with the Blue handle like that, but prety close. Need to beat it up and do the weathering, but wanted to share before then anyway. Store bought from Wal-Mart for $11, its the 15 inch wide version, accurate to measurements of Wall-E at the Builders Club.

There is a version where the top of the handle and the button on the right is blue, but no version where there is a separate top crossbar like the movie shots.

my_walle_cooler.jpg
 
The Blue cap to the handle shouldn't be too hard to produce.
You may be able to make it out of styrene.
Either vacuum formed or boil it and form it to shape.

Scot
 
GREAT start William!!!! Can't wait to see you and Nik rollin this sucker around with the tyke someday.

now honest truth.....

IMHO the weathering on the cooler is fantastic, but not quite right. You are off to a great start BTW.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top