Studio Scale guys, Part identification help

D

Darthmagpie

Well-Known Member
I know most of you Studio Scale guys have already looked at the ROTS Vader helm interior identification thread:
http://www.therpf.com/showthread.php?t=2655&highlight=reveal
But I was hopping to get a fresh look of a couple key parts.
I have looked at the kit scans on studioscale.com and have been to model shops in hope that pics on the boxes would help, but no luck yet. Please take a second to look or re-look at these particular parts. Besides what is more fun that a kit part hunt.:DThank you so much, Ben

1-Part of a frame?
2-Trailer hitch?
3-rear differential?
4-?
Studioscale.JPG


As far as #3 I found these in the Tamiya 1/35 Quad Gun Tractor. close but no cigar.
reardifferential.JPG

Thanks Wackychimp
 
Last edited by a moderator:
Sorry I can't help, but turning up the refresh rate on your monitor to 75-85hz should really help the eye-strain. Just as long as it's not any lower than the real "frames per second" your eyes naturally pick up you should be all set.

Darthmagpie said:
My eyes are bleeding from looking at kit scans. Hopping a sunday night bump helps the cause.
Click to expand...
 
one-last-bump-before-I-give-up.....
Seriously any help..thoughts on scale, type of vehicle, what the part makes you think of when you see it...anything.....
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

darthbooth1978
Imperial Probe Droid studio scale model help
Replies
14
Views
1,059
Duncanator
Duncanator
Ntyrrell
Studio Scale AT-AT Parts Breakdown and ID Help
Replies
9
Views
1,005
rooker2k
rooker2k
SCUDMAN
STUDIO SCALE 3D PRINTED AT-ST
Replies
10
Views
1,058
SCUDMAN
SCUDMAN
N
Need help with my new Studio Scale X wing
Replies
12
Views
1,221
Jkirkon
Jkirkon
darthbooth1978
AMT/MPC ESB/ROTJ X-Wing studio scale miniatures
Replies
2
Views
426
division 6
division 6
Back
Top