Correctly Sized SS R2-D2 Found

TridCloudwalker

Sr Member
RPF PREMIUM MEMBER
For all those out there still searching for an R2 unit to put in your 1/24 SS models, I finally found one.

Assuming that a diameter of 3/4 of an inch is correct, there is no need to buy an entire Star Wars chess set to cannibalize a single piece. Just go anywhere that sells Star Wars figures, and pick up the R2-D2 keychain. It looks like Hasbro packaging, but is made by Basic Fun. I see these keychains everywhere, yet I can't find ANY info on them online. I picked one up at Toys R Us tonight for $3.99, and it measures a perfect 3/4 inch diameter. Detail is pretty decent, and if recast in resin and cleaned up, could look very very nice.

Here's a crappy pic I took with my phone:
DSC00120.jpg

DSC00121.jpg
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top