How do I flatten pipe?

BlindSquirrel

Sr Member
I have a project where I need to use a 1/2" copper pipe for reinforcement. The problem is, there is a section where I need to flatten the end about halfway (to an oval/football shaped profile) Obviously, I could hammer the crap out of it, but I'd like it to be as even as possible.

Any suggestions?
 
A vise?

new_vice.jpg
 
Ditto.. I've done that before with projects.. for soft copper, go slow.use a rubber (or similar) cushion around the pipe to reduce surface marking..
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top