My Obi Wan ANH weathered saber creation

Pastor Jedi

Well-Known Member
Here is an Obi Wan ANH weathered lightsaber that I have recently completed for someone made from turned aluminum and brass. It is comparable to the MR version. It has an actual cotton powder brass wind vane that is threaded onto a brass neck. It has an actual Graflex clamp with a bubble display and 2 transistors like the ones on the MR version. It also has a D ring. It has been weathered with flat and rust paint and the emitter with aluminum black liquid. It also has a blue crystal in the emitter. In the picture of the 2 sabers, the one on the bottom is an MR version for comparison bcc28@juno.com
http://cable.netghetto.org:5001/gallery2/d/5381-2/CIMG1151.JPG
http://cable.netghetto.org:5001/gallery2/d/5384-2/CIMG1152.JPG
http://cable.netghetto.org:5001/gallery2/d/5387-2/CIMG1153.JPG
http://cable.netghetto.org:5001/gallery2/d/5390-2/CIMG1154.JPG
http://cable.netghetto.org:5001/gallery2/d/5393-2/CIMG1156.JPG
http://cable.netghetto.org:5001/gallery2/d/5396-2/CIMG1157.JPG
http://cable.netghetto.org:5001/gallery2/d/5399-2/CIMG1159.JPG
http://cable.netghetto.org:5001/gallery2/d/5375-2/CIMG1160.JPG
http://cable.netghetto.org:5001/gallery2/d/5378-2/CIMG1161.JPG


http://i17.ebayimg.com/02/i/000/a8/b8/3187_1.JPG
http://i2.ebayimg.com/03/i/000/a8/b8/365a_1.JPG
http://i14.ebayimg.com/05/i/000/a8/b8/3b24_1.JPG
http://i5.ebayimg.com/05/i/000/a8/b8/3f06_1.JPG
 
Last edited:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top