Need Help! What is best way to reglue down MR saber grips on vader saber?

you could use the 3M adhesive tape that blast-tech uses for his grips.

TCSS also has the grips, with the tape already attached.

only place i know to actually just get the rollls of tape, is blast-tech itself. i always ordered a couple rolls when i got grips, so incase of one coming off, or i had to pull them off and reset them, i had fresh adhesive for the grips.

so try blast-tech for some rolls of the 3M adhesive tape.
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top