Dr who 'Blink' angel mask

frosty

Sr Member
Well my sons birthday is coming up and he is a huge fan of the new dr who series,he's only five and out of the last few episodes his favourite was the Blink angel monster( even though it scared the pants of him).
So i made one as a surprise
Heres the clay sculpt, done in water clay over the smallest headform i had
IMG_0003-7.jpg

And the final latex mask, i used an old toothbrush for the speckled stone effect
IMG_0004-9.jpg


IMG_0005-7.jpg

And finally here he is in his new mask, dont blink!
IMG_0007-4.jpg
 
Thanks again
Maybe if there was enough interest, Neil would add the blink angel to his replica line, he is a member here
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top