DH-17 ESB detail info needed

3DpropsNL

New Member
Hi there,

ATM we are busy creating a DH-17 ESB model and we are kinda stuck on this part on the front of the magazine part.
Who can provide me with a front shot of this? Or can you tell me what it is?
Magfront.jpg
 
The best image I have found that shows it somewhat:
DSC_5152.jpg

I think it could be just about anything that is rectangular. All blasters were resin-cast whole and there are bubbles, chafe, paint runs, dust - all sorts of artifacts.
 
I think OdiWan was talking about the rectangular lug that holds the "D ring" on the back of the L2a3 endcap
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top