robpauza
New Member
Hi guys,
I just started on this tonight. I'm modeling it in two main pieces for 3d Printing. So far, I just have the outside modeled, but the inside will print separately and will glue inside the outer shell. I'm doing it that way to hide the rough surface that the support material will leave. The first half is printing now and will be done in about 40 hours. :sleep
For now, I'm just making a 10" diameter shield. I may do a full scale later if it turns out well. Anyway, here's a few wires and renders.
Thanks for looking,
-Rob
I just started on this tonight. I'm modeling it in two main pieces for 3d Printing. So far, I just have the outside modeled, but the inside will print separately and will glue inside the outer shell. I'm doing it that way to hide the rough surface that the support material will leave. The first half is printing now and will be done in about 40 hours. :sleep
For now, I'm just making a 10" diameter shield. I may do a full scale later if it turns out well. Anyway, here's a few wires and renders.
Thanks for looking,
-Rob