Thermal detonator

Shockbolt said:

This thread shows photos of my Thermal detonator project, 3D models based on photos of the Master Replicas version. I would like to add working electronic sound/light/switches to it as well, as of now, I've hacked a bike 3 led-light array to be used for one of them. IF only there were more Disney hot potato Thermal detonators available, I would gut a few of those for the parts needed.

3D models designed in Autodesk Fusion 360, then 3D printed by Shapeways:

http://www.digitalartwork.no//RebelLegion/shapeways_3d_prints_06.png

http://www.digitalartwork.no//RebelLegion/shapeways_3d_prints_04.png



http://www.digitalartwork.no//RebelLegion/shapeways_3d_prints_05.png

http://www.digitalartwork.no//RebelLegion/20170415_135609.png

http://www.digitalartwork.no/RebelLegion/20170415_135744.png

http://www.digitalartwork.no/RebelLegion/20170415_135853.png

http://www.digitalartwork.no/RebelLegion/20170415_140020.png

http://www.digitalartwork.no/RebelLegion/20170415_140037.png

- - - Updated - - -

The two half spheres are designed so they can be screwed on/off eachother with a tiny twist. The top switch is designed to be held in place with a tiny screw.

Click to expand...

Wimismith said:

Looks really good, much better than the one I made.


Sent from my iPhone using Tapatalk

Click to expand...

Panaflex said:

These are great. Wish I knew more about small electronics work so I could wire up one of these with lights and sounds.

Click to expand...